Industry scenarios are driven by process quantities, not room geometry: fuel consumption, burner count, mill type, kiln type, tunnel cross-section and platform count. The system converts them into the flow and total pressure needed for selection, and states the basis for the gas temperature it uses.
Eleven industry process scenarios:Covers solvent drying and coating, incineration air, VOC adsorption and rotors, paper hoods and bag areas, fuel boiler air, mill primary air, sintering draught and cement kiln tail, tunnel and shield ventilation, metro piston wind, non-solvent material drying, and tunnel kilns and annealing furnaces.
Process quantities enter the formulas:Enter fuel net calorific value, consumption, excess air ratio and burner count; the system applies combustion and flue-gas formulas instead of asking you to estimate a flow.
Gas temperature taken from the process:For high-temperature processes the gas temperature is derived by the scenario and its basis shown (for example flue-gas temperature), with density corrected accordingly so cold-air density is never applied to a hot duty.
Same selection engine as general scenarios:The result feeds the same sample selection and curve engine as the general scenarios, so reports stay consistent.
FAQ
How do industry scenarios differ from general ones?
The inputs differ: general scenarios convert room or duct geometry and air-change rates, industry scenarios convert process quantities (consumption, unit count, kiln type, cross-section). Both then run the same sample selection.
Which flow is wet, dry or standard?
The page lists site wet-basis flow, dry-basis flow and standard flow (Nm³/h). Selection uses the site wet-basis flow; the other two are for checking against the process owner's figures.
What if the process values are uncertain?
Run once with the defaults to see the trend, then replace them with confirmed values and rerun. The calculation basis marks which values are scenario defaults and which you entered.
Fan Sample Selection · Fan Sample Selection System